Manitowoc SD0853W Specifiche Scaricare il pdf (Pagina 47)

Section 4 Maintenance

Part Number 000000966 10/09 4-5

Multiple Evaporator Ice Machines

A. Remove Splash Shields.

• Grasp the top center of splash shields.

• Lift up and then out.

B. Remove ice thickness probe.

• Compress the hinge pin on the top of the ice

thickness probe.

• Pivot the ice thickness probe to disengage one pin

then the other. The ice thickness probe can be

cleaned at this point without complete removal. If

complete removal is desired, disconnect the ice

thickness control wiring from the control board.

C. Remove the water trough shield.

• Grasp the water trough shield in the center and the

left end.

• Flex the water trough shield in the center and pull the

left end forward until clear of the side wall. Repeat for

the right end.

• Pull water trough shield forward to remove.

D. Remove the water trough.

• Depress the two tabs on the top of the water trough.

• Turn left and right ice dampers down to clear water

trough.

• Pull forward on the water trough to remove.

NOTE: Proceed to page 4-6, Step 7.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 67 68

Nessun commento

Manitowoc SD0853W Specifiche Pagina 47